The rule starts with a measurable width window
FIM article 01.33.01 sets the permitted handlebar width at no less than 600mm and no more than 850mm. It is a technical-inspection boundary, not a recommendation about personal riding style, and the published rule does not prescribe one preferred bend or rise inside that range.
Padding must cover the impact area
A handlebar with a crossbar must carry a protection pad on that crossbar. A bar without a cross member still needs a pad in the centre, positioned to cover the handlebar clamps widely. The requirement follows the likely contact zone rather than depending on one bar construction.
Ends, materials and repairs are also controlled
Exposed handlebar ends must be plugged with solid material or covered in rubber. Handguards, when fitted, must use shatter-resistant material and retain a permanent opening for the hand. Composite handlebars are not authorised, while welding a light-alloy handlebar as a repair is expressly prohibited.
Full lock must leave room for the rider’s fingers
Solid steering stops must maintain at least 30mm between the handlebar, including its levers, and the fuel tank at full lock. The regulation identifies trapped fingers as the hazard, turning steering clearance into a rider-protection measurement rather than a workshop preference.
This is a scrutineering explainer, not a set-up prescription
The official rule defines the safety envelope but does not tell a rider to cut a compliant bar or alter an approved motorcycle. Any adjustment still has to preserve the width, controls, stops and clearances checked by the relevant organiser. Euro MX Community created the accompanying text-card in-house and reproduced no race photography.
Facts are frozen to the verification date shown above. Any later correction will be added visibly.
Primary source checked internally: FIM official 2026 Motocross Technical Regulations, version 1 August 2026, articles 01.33.01–01.33.08; checked 22 November 2026.




