A motocross footrest can be fixed or folding
Article 01.39.01 of the current FIM Motocross Technical Regulations permits a footrest to be solidly fixed or built as a folding unit. The common spring-loaded motocross design is therefore not mandatory by itself, but once a folding design is used it must meet the return and edge requirements.
A folding peg must return automatically
The FIM requires a device that brings a folded footrest back to its normal riding position. That matters after the peg is deflected by a rut, jump face or contact: the rider must not rely on manually resetting it before regaining stable support.
The outer end needs an 8mm safety radius
The rule also calls for integral protection at the end of the footrest with a radius of at least 8mm. In practical terms, the outside end cannot finish as a narrow exposed point. The measurement is a minimum radius, not an overall footrest-width requirement.
Grip teeth have two limits
Footrest teeth may provide boot grip, but the FIM says they must not be sharp and may be no more than 10mm high. The regulation therefore balances traction in mud with a defined limit on protruding edges around the rider and other competitors.
This is a technical explainer, not a product verdict
The regulation defines competition eligibility and safety geometry; it does not rank aftermarket brands or approve a specific footrest. Riders should inspect the return action, end shape and teeth after impacts and use the event’s technical control for a definitive compliance decision. Euro MX Community checked the 1 August 2026 FIM version on 21 November and created the accompanying text-card in-house.
Facts are frozen to the verification date shown above. Any later correction will be added visibly.
Primary source checked internally: FIM official 2026 Motocross Technical Regulations, version 1 August 2026, article 01.39.01; checked 21 November 2026.




