FACT-CHECKEDWritten in-house from a primary official source. No copied article and no outbound detour.

Protection comes before accessories

Article 01.67 of the 2026 FIM Motocross Technical Regulations states that a helmet is made to provide protection and is not a platform for attaching foreign objects. The wording is deliberately broad: eligibility starts with the helmet as approved protective equipment, not as a convenient mounting point.

Fit, condition and fastening are checked together

Every participant in practice and racing must wear a properly fastened protective helmet that fits correctly and is in good condition. It must use a chin-strap retention system. A Technical Steward may also check that the fastened strap cannot slip over the chin and that the helmet cannot be pulled off from the back.

The shell and face cover must remain intact

The protective lower face cover must be fixed, non-detachable and non-moveable. The outer shell may not be made from more than one piece, and the regulations say that no alteration may be made to the helmet’s construction. Only a helmet carrying the required valid FIM homologation label is permitted under article 01.70.

An impact triggers another technical check

After an accident involving an impact, the rider must present the helmet to the Technical Steward for examination. If it is defective or fails the technical requirements, the steward marks its international approval marks in red, retains it until the end of the event and requires the rider to submit another helmet for approval.

Non-compliance can stop the ride

The helmet requirements are not guidance notes: article 01.67 says failure to observe them entails exclusion. The practical takeaway is simple—start with a currently homologated helmet, keep its construction unchanged, fasten it correctly and return it for inspection after an impact.

Editorial note
Facts are frozen to the verification date shown above. Any later correction will be added visibly.
Primary source checked internally: FIM official 2026 Motocross Technical Regulations, articles 01.67, 01.69 and 01.70; version 18 February 2026, checked 13 November 2026.